ExciteR 55 Aerosol

Can not be shipped by expedited choices, per air regulations.

*RESTRICTIONS:

• Not for use in outdoor residential misting systems (indoor or outdoor) or metered release devices. The product should only be used when can temperature is above 60° F. If can temperature is below 60° F, the store at room temperature until a temperature above 60° F is reached. Use only with the supplied actuator and injection tube or other application equipment approved by the registrant. Do not allow spray to contact plastic, painted or varnished surfaces or directly into electronic equipment such as radios, televisions, computers, etc. Do not apply directly to processed feed/food. Do not apply while food processing is underway. Remove or cover exposed food and drinking water before application. Remove or cover dishes, utensils, food processing equipment, and food preparation surfaces, or wash them before use. Do not enter or allow others to enter treated areas until vapors, mists, and aerosols have dispersed, and the treated areas have been thoroughly ventilated. Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. Do not use in aircraft cabins. When used in dairy barns or facilities: Close milk bulk tank lids to prevent contamination from spray and from dead or falling insects. Remove or cover milking utensils before application. Wash teats of animals before milking. Remove pets, birds (except in commercial poultry operations), cover fish aquariums before spraying. In hospitals or other medical care facilities, remove patients prior to treatment. Ventilate treated areas for 2 hours prior to returning patients. Do not make space spray applications when the facility is in operation. During space spray applications, cover or remove food. During space spray applications, cover food processing surfaces or clean after treatment with a suitable detergent and rinse with potable water before use. Do not make outdoor applications during rain. Do not wet plants to point of runoff or drip. Application is prohibited directly into sewers or drains, or to any area like a gutter where drainage to storm sewers, water bodies, or aquatic habitats can occur. Do not allow the product to enter any drain during or after application. Do not apply more than one time per day.
• Residential Outdoor Surface and Space Sprays, Except for Outdoor Fogging Devices: All outdoor applications if permitted elsewhere on the label, must be limited to spot or crack and crevice application only, except for the following permitted uses: Treatment to soil or vegetation around structures; Applications to lawns, turf and other vegetation; Applications to building foundations, up to maximum height of 3 feet; Applications to underside of eaves, soffits, doors, or windows permanently protected from rainfall by a covering, overhang, awning, or other structure; Applications around potential pest entry points into buildings, when limited to a surface band not to exceed one inch in width; and Applications made through the use of a coarse, low pressure spray to only those portions of surfaces that are directly above bare soil, lawn, turf, mulch or other vegetation, as listed on this label, and not over an impervious surface, drainage or other condition that could result in runoff into storm drains, drainage ditches, gutters, or surface waters, in order to control occasional invaders or aggregating pests.
• Maximum application rates are as follows: For indoor and pet premises applications: Surface - 0.056 lb ai/1,000 sq ft; Crack and crevice - 0.22 lb ai/1,000 sq ft; Space - 0.00033 lb ai/1,000 cubic ft; For outdoor applications: Surface - 0.0075 lb ai/1,000 sq ft; Crack and crevice - 0.22 lb ai/1,000 sq ft.