Aprehend Biopesticide Treatments

Bed Bugs

• The spray gun nozzle should be held approximately 3 to 4 inches from the target surface. Move the gun at a rate of approximately 4 to 5 seconds per yard.
• Aprehend™ should be applied to surfaces where bed bugs are likely to walk. Application of a consistent 2” spray barrier will provide optimal bed bug control. Correct application of Aprehend™ according to these instructions will result in an application rate of 1 fl oz per 100 linear ft.
• Do not dilute this product.
• Aprehend must be applied at low volume application rates using a Low Volume Low Pressure spray applicator.
• DO NOT USE STANDARD (HIGH VOLUME) SPRAY APPLICATION EQUIPMENT TO APPLY THIS PRODUCT.
• Contact ConidioTec LLC or your distributor for specific information about applicator system
• Re-entry:Keep unprotected persons and pets out of treated areas while treating and after treating for 4 hours.

Low Volume Sprayer Kit and Lithium Battery can not be shipped by expedited choices, per air regulations.

Precautions and Restrictions

• Do not apply to bare floors – slipping hazard.
• Do not apply on wet surfaces.
• Do not apply on fresh painted surfaces
• Do not apply to wallpaper
• Do not apply to silk
• Do not apply on hot surfaces.
• Do not apply where electrical short circuits can occur.
• Do not apply to furniture, upholstery or mattresses where prolonged contact with humans will occur.
• Do not apply to flat surfaces where prolonged human contact will occur.
• To ensure long-term residual activity, do not clean or wipe spray residue from treated surfaces.
• Before application to fabrics, always spray a small inconspicuous area to check for staining