Fireback Bedbug and Insect Spray gives a very quick knockdown and residual control for bed bug protection. This aerosol sprays in a fan, mist, or stream pattern without a crack and crevice straw.
Can not be shipped by expedited choices, per air regulations.
Fireback Bedbug and Insect Spray: Bed Bug Protection
Fireback Bedbug and Insect Spray gives a real quick knockdown and residual control for bed bug protection with the combination of pyrethrin and permethrin as its active ingredients. This broad-spectrum aerosol will spray in a fan pattern or mist pattern and a smaller stream pattern without the need for a crack and crevice straw. Fireback has the additional benefits of being non-staining and odorless. It has a water based formula.
Fireback Bedbug and Insect Spray - Kills More Than Bed Bugs
Not only does Fireback Bedbug and Insect Spray kill bedbugs, but also effectively eliminates a multitude of other insects such as ants, beetles, fleas, ticks,lice, millipedes, spiders to name a few. Fireback may also be used in food/feed processing plants as well as non-food/feed areas. Fireback Bedbug and Insect Spray may be used inside or outside.
Top Features
Kills on contact
Seeks out bugs where they hide
Non-Staining
No unpleasant odor
Kills bed bugs
Kills crawling insects and provides long term protection up to 3 months
Can not be shipped by expedited choices, per air regulations.
For residential/commercial use. Can be used in non-food/feed areas of food/feed processing plants.
Yield
N/A
Mixture|Application
Spray with either the fan pattern or stream pattern
Retreatment
As needed
Shipping Restrictions
AK
More Instructions
Directions for Use for Crawling Insects
Shake the aerosol can well before using. Hold Fireback Spray surfaces 12–15 inches away at an upright angle. Spray Fireback in infested cracks and crevices, voids, baseboards, under and behind sinks, cabinets, baseboards, floors, around drains and plumbing, carpets, mattresses, and furniture.
Directly spray insects if possible.
Directions for Bedbugs:
Spray mattresses, especially seams and tuffs. Disassemble beds and spray joints. Clean floors, baseboards, and mouldings. If needed, treat again. Dry all sprayed items before using them.
Surface Spray:
Use as a surface spray by treating areas at a rate of 20 seconds per 1,000 cubic feet. Leave the room and seal the area for 15 minutes. Before entering, ventilate the area to be used. Repeat treatments as needed. Please carefully read the product label for specific use guidelines.
